Waste Heat Recovery with Oscillating Heat Pipes

McCullough, C. R., Thompson, S.M., & Cho, H. (2013). Waste Heat Recovery with Oscillating Heat Pipes. ASME International Mechanical Engineering Congress & Exposition. San Diego, CA: ASME. 11, V011T06A029. DOI:10.1115/IMECE2013-66241.

Abstract

Waste-heat recovery applied in HVAC air systems is of interest to increase the energy efficiency of residential, commercial and industrial buildings. In this study, the feasibility of using tubular-shaped oscillating heat pipes (OHPs), which are two-phase heat transfer devices with ultra-high thermal conductivity, for heat exchange between counter-flowing air streams (i.e., outdoor and exhaust air flows) was investigated. For a prescribed volumetric flow rate of air and duct geometry, four different OHP Heat Exchangers (OHP-HEs) were sized via the ε-NTU method for the task of sub-cooling intake air 5.5 °C (10 °F). The OHP-HE tubes were assumed to have a static thermal conductivity of 50,000 W/m·K and only operate upon a minimum temperature difference in order to simulate their inherent heat transport capability and start-up behavior. Using acetone as the working fluid, it was found that for a maximum temperature difference of 7°C or more, the OHP-HE can operate and provide for an effectiveness of 0.36. Pressure drop analysis indicates the presented OHP-HE design configurations provide for a minimum of 5 kPa. The current work provides a necessary step for quantifying and designing the OHP for waste heat recovery in AC systems.